AppleTalk is not available on this Macintosh. You must first turn AppleTalk on using the Chooser before running this application.
The reserved PostScript scratch space must be in the range of 0 MB to 300 MB.
The job file could not be opened for proofing.
Only PhotoShop CMYK files can currently be proofed directly. Please convert the file to CMYK and then select it again.
Out of memory. The operation could not be completed.
A read error has occurred while attempting to read the job file for document '%P'. [Error %d]
The job file folder could not be made. [Error %d]
The job file could not be made. [Error %d]
The '3M Rainbow PS VM' file could not be found. Please reload it from the 3M Rainbow Proofing System disk set and then restart the Controller application.
The '3M Rainbow PS Startup' file could not be found. Please reload it from the 3M Rainbow Proofing System disk set and then restart the Controller application.
The 3M Rainbow Controller application appears to be incomplete or damaged. Please reload the software from the 3M Rainbow Proofing System disk set and then restart the Controller application.
The cassette tray has been removed from the proofer. Please replace the tray.
A problem has occured with the proofer ink ribbon. Please check that the ink ribbon is installed properly.
The proofer jammed during paper pickup and feed. Please clear the jam to continue proofing. Be sure to close the paper guide.
The 3M Rainbow Page Image file could not be made. [Error %d]
The 3M Rainbow Page Image file could not be opened. [Error %d]
The 3M Rainbow Page Image file could not be made large enough to run the PostScript interpreter. The page image file requires 71,484 KBytes of disk space.
Out of memory. The PostScript interpreter could not get the memory needed to start up.
Out of memory. The PostScript interpreter could not get the memory needed to process the proof job.
The job file could not be opened for proofing document '%P'.
Out of memory. Not enough memory exists to proof the job.
An unknown proofer error has occurred. The proof cannot be completed.
A proofer EEPROM read/write error has occurred. The proof cannot be completed.
A proofer RAM read/write error has occurred. The proof cannot be completed.
A proofer mechanical positioning error has occurred. The proofer may be mechanically jammed or damaged. The proof cannot be completed.
A Macintosh I/O error occurred while proofing. The proof cannot be completed.
A SCSI I/O error occurred while proofing. The proof cannot be completed.
An internal proofer communications error occurred while proofing. The proof cannot be completed.
The Color Map data file could not be opened. Uncorrected color mapping will be used.
The Color Map data file has been corrupted and could not be read. Uncorrected color mapping will be used.
The 3M Rainbow Proofer could not be found on the SCSI bus. Check that it is powered on, on-line, and connected properly.
The end of the ink ribbon has been reached. Please clean the proofer and replace the ink ribbon with a new one.
The cassette tray is empty. Please fill the tray.
The proofer is jammed. Please clear the jam to continue proofing.
The 3M Rainbow Proofer is not responding. Check that it is on-line.
The 3M Rainbow Proofer cover is open. Please close the cover to continue proofing.
The 3M Rainbow Proofer thermal head has become too cold. Please wait a few seconds and then try again.
The 3M Rainbow Proofer thermal head has become too hot. Please wait a few seconds and then try again.
Please place %P size paper, in the cassette tray.
The Job Queue is full. Please try again after the system has completed processing of one or more of the jobs in the queue.
Please place %P size transparency material, in the cassette tray.
The 3M Rainbow Controller software requires a Macintosh with at least a MC68020 processor. This machine cannot be used to run the 3M Rainbow Controller application.
The 3M Rainbow Controller software requires a Macintosh with at least a MC68881 math coprocessor. This machine cannot be used to run the 3M Rainbow Controller application.
The name for the 3M Rainbow Proofer must be filled in. Please give the system a name.
The name for the 3M Rainbow Proofer cannot be longer than 30 characters. Please shorten the name to 30 characters or less.
An internal 3M Rainbow Proofer engine communications error occurred while proofing. The proof cannot be completed.
The 3M Rainbow Proofer aborted the proofing cycle due to a proofing sequence error. The proof cannot be completed.
Connection to the 3M Rainbow Proofer Controller failed. Please try again.
The version of the Remote Control and Controller software are not the same. Install a copy of the Remote Control software from the 3M Rainbow Proofing System distribution disk set.
The 3M Rainbow Controller cannot handle any more Remote Control workstations at this time. Please try again later when the Controller is less busy.
The 3M Rainbow Controller is no longer responding. Please check that it is operating properly.
The 3M Rainbow Controller has been shut down.
AppleTalk Phase 2 is not available on this Macintosh. You must first install it before running this application.
The Proofer Density Compensation value must be in the range of -20 to +20.
WARNING: The current job may change the PostScript state for later jobs.
Only uncompressed CMYK TIFF files can currently be proofed directly. Please convert the file to uncompressed CMYK and then select it again.
A separation was found in the PostScript file that is not cyan, magenta, yellow, or black. The separation is being ignored.
The number of copies must be in the range of 1 to 200.
The reduction/enlargement factor must be in the range of 1 to 800.
The basic 13 PostScript fonts are not present.
The Proofer Density adjustment must be in the range -20 to +20.
The 16, 64, 128, and 196 level Calibration Table entries must be between -12 and +12.
The original 3M files cannot be overwritten. Please save your changes to a new file with a different name.
An error has occurred while writing the Color Calibration File. You may have too little disk space to write the File.
The proofer jammed during paper ejection. Please clear the jam to continue proofing.
The 255 level Calibration Table entries must be between -12 and 0.
There is a problem with the order of the color separations in the PostScript job. The job cannot be properly proofed.
The PostScript job did not complete all the separations of the proof.
This is not a valid format for a number.
The Color Map data file has been corrupted and could not be read.
The PostScript temporary file folder could not be made. [Error %d].
The '3M Rainbow PS Resources.upr' file could not be found. Please reload it from the 3M Rainbow Proofing System distribution disk set and then restart the Controller application.
The font '%P' is missing. Do you want to substitute with Courier?
The Auto Print folder could not be made. [Error %d]
The font '%P' is missing. It may have been deleted, moved, or had one of its parent folders renamed.
The selected file does not belong to font '%P'.
An error has occurred while writing the PostScript Resource File. You may have too little disk space to write the File.
An error has occurred while reading the PostScript Resource File. The PostScript Resource File may be corrupted.
Out of memory while processing the PostScript Fonts.
The selected Scitex CT file has colors other than CMYK. These colors will not be printed.
The current ink ribbon is too small for the media. Please replace the ink ribbon with an A3/WB size ribbon.
The current ink ribbon is for an exotic color. Please replace the ink ribbon with a CMYK ink ribbon.
Expected to load WB size media but found WA size. Do you want to proof on WA?
Expected to load WA size media but found WB size. Do you want to proof on WB?
The 3M Rainbow Plug-in Image file could not be created. More space is needed on your hard drive.
The 3M Rainbow Plug-in Image file could not be opened.
The 3M Rainbow Plug-in Image file could not be made large enough. More space is needed on your hard drive.
The Color Map data file has a version number newer than expected. The file cannot be used.
The Rainbow Plug-in does not have enough RAM available to proof the image. If possible, increase Photoshop's memory partition to at least 6,000K.
This version of the 3M Rainbow Controller software requires a Macintosh with a PowerPC processor. This machine cannot be used to run this 3M Rainbow Controller application.
The 3M Rainbow Controller software requires Macintosh System 7 or later. This machine cannot be used to run the 3M Rainbow Controller application.
